Cyber Tech Help Support Forums

Cyber Tech Help Support Forums (https://www.cybertechhelp.com/index.php)
-   Windows 10 (https://www.cybertechhelp.com/forumdisplay.php?f=48)
-   -   Dell Optiplex 755 (https://www.cybertechhelp.com/showthread.php?t=234917)

Jerry56 January 2nd, 2023 09:21 PM

Dell Optiplex 755
 
I have a dell optiplex 755 with windows 10. The computer have a steady yellow light and will not start the fan is running, I try disconnecting the power. Monitor
key board, speaker etc but it still will not start any suggestion?

Murf January 3rd, 2023 02:13 AM

Which FAN the processor? Power Supply Fan?

A solid light usually indicates a system component has failed. In your case I would strongly suspect the video card. What you can do is open up the case and try removing and re-seating the video card. If using on-board video then remove the memory and reseat.

No good reset the CMOS, using the jumper;

Remove only jumper on motherboard. restart computer. shut down computer replace jumper. restart. This is obviously a bios reset.

or remove the CMOS battery for about 20 sec, reboot get into BIOS if it reboots and set to defaults.

Last resort prolly the power supply.

Jerry56 January 3rd, 2023 08:23 PM

I unplug the power over night and before I open the computer I plunged it in and it work o.k

Jerry56 January 4th, 2023 06:42 AM

It went off again this afternoon but this time the amber light is not steady its flashing.

Murf January 5th, 2023 02:33 AM

Is the power supply fan turning off? If so, I would suspect the power supply is going bad.

Ensign Tzap January 11th, 2023 07:49 PM

Jerry56,


A blinking amber power button LED, usually indicates, a power supply or system board failure has occurred.


To test the motherboard, you need a know the power supply is working.
If you are comfortable around computers, you could try the following.

Unplug the cord from the power supply, hold the power button in for about 15/20 seconds, open the case, unplug the 24-pin connector from the motherboard and jump the Green wire to one of the Black wires, reconnect the power cord and if power supply fan and hard drive runs, the PSU should be good.

Note: Do not remove any wires from the plug, use a small piece of wire or a paper clip as a jumper.

Power supply checks out and the system still does not work, again remove the power cord, hold power button in for several seconds to discharge the residue power, reconnect the 24-pin connector to the motherboard.

Remove all the PCI cards, the video card [if applicable], memory, all peripherals, disconnect the data and power cables to all the drives, then check that the front panel cable is connected to motherboard, with nothing else connected to the system, reconnect the power cable and power the system on.

If you do not get any beep codes or no diagnostic lights on the front/back panel, then it would appear that motherboard has died.




Signed: Ensign Tzap

Wonderstone January 19th, 2023 09:45 AM

Did you managed to resolve the issue? Was it with the power supply?


All times are GMT +1. The time now is 04:35 PM.

Copyright © Cyber Tech Help. All rights reserved. All other trademarks are the property of their respective owners.